Halo hat brims—

Halo brims may be made from any fabric, but to be effective the material should be sheer. Malines, nets, georgette crêpe, or chiffon are all used to good effect in making this style of hat. Good-looking halo brims have been made from old georgette waists, using the back for the brim and the front and sleeves for the crown.

Only two wires are used in making this brim, the edge wire and the headsize wire. The size of the brim is to be determined and then a hoop of sprung wire cut just the length of the circumference of the brim. This wire is uncovered; the ends just meet and are joined by the use of a little clamp, the ends being inserted and pressed down with the jaws of the pliers.

Place the material from which the brim is to be made upon a flat surface. If of maline, several thicknesses may be used. Fasten this material down to the table slightly with pins or thumb tacks. Lay a circle of sprung wire on the material and pin in place. Begin by pinning the back, front, and then each side, being careful not to pull the wire out of shape. Take the work up and pin the material closely all around the edge. Cut off, allowing one-quarter of an inch to turn over the wire. Sew to the wire closely with an overcasting stitch or with a running stitch just inside of the wire. The edge may be bound with a fold of the same material, a fold of satin or one row of braid.