Poppies—

Poppies may be made from ribbon seventeen inches long and two and one-quarter inches wide. Cut two pieces five and one-half inches long. This leaves one piece six inches long. This will make five petals. Cut the ends round on the five and one-half inch pieces, and cut one end of the six-inch piece round. Beginning at the center, close to edge, gather with a small running stitch. Turn in the raw edges and draw the thread sufficiently to make the rounded ends curl over one inch, and fasten off the thread. These two long pieces make four petals. Pleat them very close at the center, sew together, finish the single petal the same and add it to the four petals. Knotted black baby ribbon or yellow stamens or both will make a beautiful center.

Morning glories—

Cut a circle of paper four inches in diameter. One quarter section of this will be the pattern for a morning glory. The circle may be larger if desired, but the size should depend somewhat upon the material used. These dimensions are for a small blossom made of taffeta silk or organdie. If made of velvet or heavy silk, the pattern should be much larger.

Lap the straight edges one-eighth of an inch in and paste in place. This makes a cone. Cut a piece of tie wire six inches in length, lap one end over several knots of yellow baby ribbon and twist securely. Push the other end of wire through the cone from the inside and draw the knots down into the point. Make a short bend in the wire at the lower point of the blossom on the outside to prevent its slipping down on the wire. The upper edge of the cone may be rolled over a piece of tie wire and pasted if necessary; usually it stays in place without either sewing or pasting. The edge should be stretched slightly. Organdie or taffeta silk will stay rolled into place without the tie wire. Water color is used most effectively on these flowers to make the shading as true to nature as possible. If made of velvet they may be sewed down flat on a hat at the side joining, when a large stamen of twisted ribbon or chenille may be made to cover the joining in the cone.