Radiating—

This is the most difficult pleating to fashion, but very handsome ornaments are made in this way. A foundation of buckram is usually required to sew the pleats on as they are laid. The two illustrations given will suffice. After these two examples are correctly copied, other models and original designs can be easily made.

Foundations of buckram—

The foundation for the second is in the shape of a low pyramid made from buckram. Cut a small circle of buckram, slash in three equally distant places from the outer edge to within one-eighth of an inch of the center. Lap a small amount and sew. Three rows or more of pleating may be used on this ornament. An ordinary ornament will require about five yards of inch-wide ribbon. The first row would be placed near the outside edge of the buckram and each pleat sewed as it is laid. The pleating should radiate from the center. To do this, the inside of the pleating will lap more than the outside. The next row will overlap this first row and the same method will be used. The pleating may be tested by holding a ruler on a line between the top and the lower edge of the pleating. The pleats should all be on a straight line between these points. The last or finishing row is the most difficult of all. The pleats at the apex should meet, and pleats at the lower overlapping edge be on a line with the rest of the pleating. A tiny bow or button is sometimes used to finish the top, but it is much handsomer if finished without either bow or button.