Wired ribbon bows—

Ribbon is sometimes wired if a stiff effect is desired. Silk, satin, velvet, or any kind of ribbon can be used. The flat ribbon wire is sometimes pasted between two ribbons with milliner's glue. Often two colors are rather effectively used in this way. The wire may also be stitched to one edge of the ribbon. This is done by turning the ribbon over the wire at the edge and stitching on the sewing machine. The ends of the wire should extend two inches beyond the ends of the loop of the bow. After the bow is arranged, these ends should be bent out and back, making loops which are sewed down to the hat. This holds the bow very firmly, especially if a small piece of buckram is placed inside the hat at the point at which the bow is to be sewed. This re-enforces the frame and makes it still more firm. If a bow is to be placed on top of a crown, a hole may be made and the ribbon which completes the middle of the bow may be brought up from the inside of the crown through this opening, over the bow, and down through this opening and fastened inside of the crown.

A narrow ribbon of velvet is very pretty twisted over a wire and two perky loops and ends made. These are very pretty perched on the edge of a brim or among flowers on the hat.

True lovers' knot—

This is not, strictly speaking, a bow, but comes under this head. The ribbon used is made into the knot and sewed flat as it is made. It may be sewed on the brim or side crown and is very effective made of gold ribbon.