To pin in place on the frame—

Place the outer edge of the straw even with the outer edge of the brim, beginning at the center back, allowing three inches to extend to the right. Pin in place and baste all the way around until the center back is reached. Curve the second row gradually up from the center back; do not make an abrupt curve, until the correct lap is reached, usually one-eighth of an inch. There will be found a thread at the edge of most braids which may be pulled up to take out the extra fullness when sewed on a curve. The outside edge of the first row must be left free for the edge of the fabric, which covers the other side, to be slipped under. Do not begin sewing until the second row is basted in place.

To sew—

Bring the needle through the edge of the braid at the lap from the under side and take a tiny stitch, stabbing the needle through the braid and the buckram; the small stitch on the right side will be hidden if the thread is not pulled too tight. Take a stitch on the wrong side from one-quarter to one-half an inch in length, depending upon the width and quality of the braid. Continue basting and sewing the braid until the headsize is reached and the braid extends up above the headsize wire one inch. If the brim is wider at some points than at others, the wider side must be filled in with short strips following the same curve, being careful that the ends are left long enough to extend up beyond the headsize wire one inch. When the brim is very much wider at some points, short pieces of braid may be worked in at intervals as the braid is sewed; this would not make such an abrupt curve, and the general lines of the braid would be more pleasing.

When one side of the brim is to be covered with fabric, fit this to the brim, baste at the headsize wire and cut the edge, allowing one-quarter of an inch to lap over the edge. Remove the basting from the first row of braid and tuck the edge of the fabric under. Pin and slipstitch to place through the straw.